forum.datacad.com

Hello,

We just upgraded to DataCAD 11, and have noticed that the "Identify" hotkey which used to be "I", now only works if we hit "Shift+I". Does anybody know how we can revise this back to just hitting "I"? Thank you in advance....

I think "i" was for digitizer, which I never used and don't think it worked unless you used a digitizer or tablet(not sure), and "I" was Identifiy. You or someone else might have created a custom dcadwin.msg file that you have been using that will have to be intergrated into the new dcadwin.msg file, and updated with every version including patch.

Or..... you could have been using the productivity keyboard pack from version 8 or 9, which is not included anymore, but maybe someone has created a revison for that for 11.

Either way messing with the dcadwin.msg file is not recommended unless you have a good understanding of programing. Also it is not supported by Datacad.

Thank you Josh,

I will try to get DataCAD tech support on this one. I appreciate your time and consideration.