Topic Title

A colleague of mine asked for a .dxf of a drawing so he could review and plot it himself using Design Review from Autodesk. The problem is that the ‘sheet size’ is displaying 11.0 x 8.5 in. The plot setting before I exported the drawing was set to 30” x 42”.
Any ideas as to why this is?


-Redd

Is the 8.5x11 setting showing up in Design Review? I use it quite a bit (to plot DWF's) and haven't had any problems like that. To be honest, though, I've never tried it with a DXF.

Is the 8.5x11 setting showing up in Design Review?

yes.

I've tried both DXF and DWF with the same results.
I even uninstalled my version of Design Review and reinstalled it from AutoDesks website, installed the service pack and it's still showing as 8.5x11.0 in the 'properties' tab.


-Redd