Had a question from an acquaintance last night and was mystified by it. I've never had it happen so had no solution. She is using version 10 and has a residential plan file where certain lines are visible, but non-identifiable nor printable. They don't show up on the plot preview while in MultiPlot.
This happens if she activates the layer in a GoToView. This leads me to believe that the GoToView is allied to the problem because of the relationsip of the GoToView and MultiPlot.
If she goes to the layer menu and just turns the layer on or off normally, the lines are identifiable and editable. I failed to ask if they show up when she uses QkLayout plot preview.
Any suggestions?
Thanks much,
Woody
This happens if she activates the layer in a GoToView. This leads me to believe that the GoToView is allied to the problem because of the relationsip of the GoToView and MultiPlot.
If she goes to the layer menu and just turns the layer on or off normally, the lines are identifiable and editable. I failed to ask if they show up when she uses QkLayout plot preview.
Any suggestions?
Thanks much,
Woody