RC24
After laying a detail on a sheet, and using Layout/Rotate (S2) to place the detail, then wanting to move the detail to re-position it on the sheet, the detail rotation angle is reset on moving the detail twice.
1. Place the detail on the sheet at the required rotation angle,
2. Select the detail from the side menu to 'release' it to the crosshair to re-position - the detail remembers the original rotation angle and can be re-positioned okay,
3. Repeat #2 above and the rotation angle is reset requiring the original angle to be input again.
Wishlist
1. Include the ability to display the MSP detail showing all entities instead of just the extents. This may include a "Max. entities" value where a user can set to display the number of visible entites up to a set maximum. Seeing the linework, especially when rotated instead of the extents will help placement on the sheet.
After laying a detail on a sheet, and using Layout/Rotate (S2) to place the detail, then wanting to move the detail to re-position it on the sheet, the detail rotation angle is reset on moving the detail twice.
1. Place the detail on the sheet at the required rotation angle,
2. Select the detail from the side menu to 'release' it to the crosshair to re-position - the detail remembers the original rotation angle and can be re-positioned okay,
3. Repeat #2 above and the rotation angle is reset requiring the original angle to be input again.
Wishlist
1. Include the ability to display the MSP detail showing all entities instead of just the extents. This may include a "Max. entities" value where a user can set to display the number of visible entites up to a set maximum. Seeing the linework, especially when rotated instead of the extents will help placement on the sheet.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com