DC12.02.03.01
I've experienced this for several weeks now across a number of files:
1. After an unknown period of time (!) walls with only be partially displayed whenever anything is done in the drawing file (pan, erase, draw a wall, insert a door etc.). Pressing Esc has no effect, only Update will re-show everything again. In some instances, the wall(s) are visible on screen but are not able to be selected until Update is pressed. Attempting to 2linetrim a wall that's there and one that isn't (even if it's visible), causes an instant crash of the file. Doing a Saveas or Purge had no effect.
2. I've just discovered that a common item I did with each of the other files was to turn Autoupdate ON in MVW #1....I've just turned it off and it appears to have stopped the anomalies.
I've experienced this for several weeks now across a number of files:
1. After an unknown period of time (!) walls with only be partially displayed whenever anything is done in the drawing file (pan, erase, draw a wall, insert a door etc.). Pressing Esc has no effect, only Update will re-show everything again. In some instances, the wall(s) are visible on screen but are not able to be selected until Update is pressed. Attempting to 2linetrim a wall that's there and one that isn't (even if it's visible), causes an instant crash of the file. Doing a Saveas or Purge had no effect.
2. I've just discovered that a common item I did with each of the other files was to turn Autoupdate ON in MVW #1....I've just turned it off and it appears to have stopped the anomalies.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com