Clip Cube HLR Out of Ortho Projection
Posted: Thu Mar 06, 2008 2:51 pmHello,
This is a simple 3D model, in Isometric view:
I've create a Clip-Cube using this viewer position, covering partially the model, and turning it ON (the CC):
When I make a HLR (Clip Cube ON) I get this result:
If I position the observer in the Frontal View or in any side view (left or right) the result is OK:
But if I set another viewer position using Elevation/New Elevation:
The result is this:
If I'm not mistaken, this anomalous behavior was present among late betas.
Thanks,
Miguel
This is a simple 3D model, in Isometric view:
I've create a Clip-Cube using this viewer position, covering partially the model, and turning it ON (the CC):
When I make a HLR (Clip Cube ON) I get this result:
If I position the observer in the Frontal View or in any side view (left or right) the result is OK:
But if I set another viewer position using Elevation/New Elevation:
The result is this:
If I'm not mistaken, this anomalous behavior was present among late betas.
Thanks,
Miguel