Is there a plan for IFC import/export?
http://en.wikipedia.org/wiki/Building_I ... n_Modeling
http://en.wikipedia.org/wiki/Industry_F ... on_Classes
Today I get a IFC drawing.
After a little bit googling I found this:
http://www.ifcwiki.org/index.php/Free_Software
With the IFC2SKP pluging I can import IFC into Sketchup.
Than I tried to paste the SKP model into DataCAD.
After 30 minutes I closed DataCAD hard.
Is the model to big? 10MB
I imported into KT and it works fine after 30 seconds.
But I can´t export from KT to DataCAD.
Any other ways?
Martell
http://en.wikipedia.org/wiki/Building_I ... n_Modeling
http://en.wikipedia.org/wiki/Industry_F ... on_Classes
Today I get a IFC drawing.
After a little bit googling I found this:
http://www.ifcwiki.org/index.php/Free_Software
With the IFC2SKP pluging I can import IFC into Sketchup.
Than I tried to paste the SKP model into DataCAD.
After 30 minutes I closed DataCAD hard.
Is the model to big? 10MB
I imported into KT and it works fine after 30 seconds.
But I can´t export from KT to DataCAD.
Any other ways?
Martell
Martell Opitz
martell.opitz@team-anymotion.de
C86TS, Q9000, GF GTX 260M, 4 GB RAM, 26" FS TFT@ 1920x1200 XP 64/Windows 7 64, Latest DataCAD
martell.opitz@team-anymotion.de
C86TS, Q9000, GF GTX 260M, 4 GB RAM, 26" FS TFT@ 1920x1200 XP 64/Windows 7 64, Latest DataCAD