IFC
Posted: Tue Jul 15, 2008 5:26 am
Is there a plan for IFC import/export?
http://en.wikipedia.org/wiki/Building_I ... n_Modeling
http://en.wikipedia.org/wiki/Industry_F ... on_Classes
Today I get a IFC drawing.
After a little bit googling I found this:
http://www.ifcwiki.org/index.php/Free_Software
With the IFC2SKP pluging I can import IFC into Sketchup.
Than I tried to paste the SKP model into DataCAD.
After 30 minutes I closed DataCAD hard.
Is the model to big? 10MB
I imported into KT and it works fine after 30 seconds.
But I canĀ“t export from KT to DataCAD.
Any other ways?
Martell
http://en.wikipedia.org/wiki/Building_I ... n_Modeling
http://en.wikipedia.org/wiki/Industry_F ... on_Classes
Today I get a IFC drawing.
After a little bit googling I found this:
http://www.ifcwiki.org/index.php/Free_Software
With the IFC2SKP pluging I can import IFC into Sketchup.
Than I tried to paste the SKP model into DataCAD.
After 30 minutes I closed DataCAD hard.
Is the model to big? 10MB
I imported into KT and it works fine after 30 seconds.
But I canĀ“t export from KT to DataCAD.
Any other ways?
Martell