Topic Title

Hi everyone.
Can someone Help me with how to place a curved roof on a drawing.

Regards Rod.

I think the simpest way is to draw the elevation in 2D, model a curved slab horizontal to it, and then rotate that 90 degrees.

Well Rod,

You haven't detailed the shape of your roof, when viewed by orthografic projection.
You can use a partial Horizontal Cyllinder as well. May be you will need to 'Explode' it into polygons to make cuts and take it to the final shape.

If it's shape is regular, you could also try a 'covered' polyline, where you can choose a curved shape too, and editing later to make the shape finishing.
In this case you should work on orthografic projection, exploding it later to change the position.

Indeed, there are several options available, regarding the complexity of your roof.

Hope this helps,
Miguel

Hi, Nick and Miguel Thanks for the help Ive used a bit of the advice from each of you and its come up quite nicely thanks again.

Regards Rod.