I am plotting to an HP Design Jet 430 from DC11. I use two paper sizes, 18X24 & 24x36. I have a 24" wide roll of paper installed on the plotter. Obviously, the most efficient use of the paper would be that drawings on either paper size print out with a 24" side coming out of the plotter first. However, no matter what setting I change, the 18X24 drawings persist in coming out with the 18" side first, so that I have to trim the paper. What a pain! I have tried to set the rotate option in the plotter setup in DC. I have also tried to make the appropriate settings via the printer setup from control panel in Windows XP. Nothing seems to make a difference.
Any suggestions?
Thanks!
Any suggestions?
Thanks!