Ever wanted to know how to perform a specific operation? Ask the experts.
#78069 by Mark Bell
Tue May 19, 2020 8:48 pm
There's a push from contractors and their surveyors for set out measurements to be in UTM Northings and Eastings (X/Y) format (and sometimes X/Y/RL for spot heights) which only requires a reference point noted on the drawing and the corresponding coordinate table making it easier for the surveyors to do the set out compared to referencing grids with offset dimensions. Unless I've missed it, the Scale Type menu doesn't appear to offer this option?

Using an online Lat Long to UTM converter, a site's E+N can be calculated which can be cross checked against survey data. If we then need to document the E+N coordinates, particularly for hard landscaped areas in a project how does DataCAD create accurate E+N coordinates on the drawings? Can these new coordinate points also be output to say an Excel format?

052020b.jpg

052020a.jpg

Who is online

Users browsing this forum: No registered users and 5 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984