Screen refresh
Posted: Wed Jul 20, 2005 3:49 pm
Every now and then I execute a command then get too anxious and start to wheel zoom before the refresh completes.
I get a note saying the refresh has been stopped. I try to do a refresh but nothing happens. The only way I have found to "see everything" after that is to close out and open the drawing again.
Any thoughts?
Thanks.
Eric
I get a note saying the refresh has been stopped. I try to do a refresh but nothing happens. The only way I have found to "see everything" after that is to close out and open the drawing again.
Any thoughts?
Thanks.
Eric