As Tony indicated, you can not change the behavior of the left-hand menus. However, I assume you are referring to the Measures icon on the Edit toolbar. If so, locate the file draw.dtb (usually located in <DataCAD Home>\support files\toolbars) and open it in NotePad. At the end of the file, change the following:
To:
Hope that helps,
Dave
Code: Select all
[MEASURE]
Hint=Measure drawing entities and perform take-offs
Icon=DTB_Measure
L=26
To:
Code: Select all
[MEASURE]
Hint=Measure between 2 points
Icon=DTB_Measure
A=^:^F7^F4^
Hope that helps,
Dave
Last edited by David A. Giesselman on Fri Jul 22, 2005 10:40 am, edited 1 time in total.
David A. Giesselman
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.