How to make materials from jpeg or bitmap
Posted: Mon Dec 15, 2014 5:34 pmWould someone be so kind as to walk me through the process of saving a jpeg from the Internet and then to making it a wall material. I had some success and some failure.
The wall has line 1 face material on one side and line 2 the material is facing the inside of the wall. In sketchup I would just use reverse faces but I don't know how to reverse the face in DataCAD. This is a stone wall since I could not find any stone walls in the DataCAD material and texture folders. Thanks for any help. I am going to write it down this time so I will remember how to do this in the future.
The wall has line 1 face material on one side and line 2 the material is facing the inside of the wall. In sketchup I would just use reverse faces but I don't know how to reverse the face in DataCAD. This is a stone wall since I could not find any stone walls in the DataCAD material and texture folders. Thanks for any help. I am going to write it down this time so I will remember how to do this in the future.