Page 1 of 1
Doing an HLR on a ClipCube?
Posted:
Thu Jan 15, 2015 4:56 pm
by Neil Blanchard
Hi,
I've got a 3D model and I have put a 3D CC around it to isolate a curvy wall. When I try to then do an hidden line removal, the CC is ignored.
Is this how it is supposed to work?
Re: Doing an HLR on a ClipCube?
Posted:
Thu Jan 15, 2015 5:51 pm
by David A. Giesselman
Toggle On ClipCube in the Hide menu?
Dave
Re: Doing an HLR on a ClipCube?
Posted:
Fri Jan 16, 2015 8:55 am
by dmartens
I tried that on one of my models and it still ignored the 3D CC. Made sure my z base and z height were well below and above the extents of the model but still didn't work. Anything else I might be doing wrong. Thanks.
Dan
Re: Doing an HLR on a ClipCube?
Posted:
Mon Jan 19, 2015 8:58 am
by Neil Blanchard
Thanks Dave - that works for me. I had completely forgotten that there was a CC option in the HLR menu. I was assuming that the current view would be used in the HLR.