Ever wanted to know how to perform a specific operation? Ask the experts.
#65741 by CADwk
Fri Jan 30, 2015 3:08 pm
Hello all,

I use to be able to see more info when I clicked on a line such as bearings etc, however, now I can only see the length when I hit alt+X+ F3. The only information that shows up is the selected measurement. How can I see the x and y coordinates too. I t appears to be disabled.

Thanks,
CADwk

:roll:

Who is online

Users browsing this forum: No registered users and 6 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984