Topic Title

I am using DC 16. I have an DWG file where my building walls were translated as polylines. How do I convert the polyline to lines to allow partial erase? Or can I edit the polyline in 3D some how? This is a 2D dwg, 3D not needed.

I read in the forum there is a Poly2line macro out there, but I'm not finding it on the site. Any help there??

Any pointers or redirects greatly appreciated!

Many, Many Thanks!
Gene

Curves, Polyline, Edit
You can then either edit the polyline, or use S3 to change to lines.

Thanks Roger! That worked like a charm, but you knew that didn't you!
Thank you SO much for the response.
Genee