Page 1 of 1
Breaking up hatches
Posted:
Mon Apr 18, 2016 11:14 am
by adamsalaz
I was wondering if there was a way to break-up hatches without using void? Basically cutting a hatch into two hatches, that would make things easier when drawing multiple hatches in a drawing file.
Thanks.
Re: Breaking up hatches
Posted:
Mon Apr 18, 2016 12:07 pm
by Roger D
I've used a polyline knockout on to do that.
Re: Breaking up hatches
Posted:
Wed Apr 20, 2016 10:24 am
by Neil Blanchard
You can use the Curves / Polyline/ Edit menu to do this.
Re: Breaking up hatches
Posted:
Wed Apr 20, 2016 12:23 pm
by MtnArch
You can also get to it through Hatching/Boundary/Edit (always lots of ways to get to DC's commands!).
Re: Breaking up hatches
Posted:
Thu Apr 21, 2016 2:48 pm
by Neil Blanchard
Does that menu let you edit Smart Arrows?
Edit: it does - because that takes you to the same menu.