Just a suggestion, have you tried knockout on the text as you can adjust the x-factor to knockout the line work? The other option is to increase the gap in the source graphics to get it closer to the output line type?
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Couple things to try depending on what you want exactly.
- You can try changing the spacing factor when you are creating the linetype
- reduce or enlarge your source
- You can try changing the spacing factor when you are creating the linetype
- reduce or enlarge your source
Thanks! - Josh
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.
Thanks Mark & Josh
Looks like adjusting the scale factor after drawing with the line is the easiest way to go at present till I figure out the scaling when creating the custom line type.
Looks like adjusting the scale factor after drawing with the line is the easiest way to go at present till I figure out the scaling when creating the custom line type.
Who is online
Users browsing this forum: No registered users and 55 guests