Page 1 of 1

Enable snap identifier

PostPosted: Mon Mar 16, 2020 11:36 am
by joeferguson
In the old days of DC 11, 12 and 17 I could hover over a snap point and a little box would appear that tells me what type of snap would occur (nearest, perp, end point etc.).

It's not there in DC 21. Probably a switch somewhere but I have looked and can't find it. The forum suggests in a couple of different posts it might have been in Tools/Program Preferences/Interface but not there today. Has it moved?

joe

Re: Enable snap identifier

PostPosted: Mon Mar 16, 2020 12:31 pm
by Roger D
It is under the Drawing tab, Dynamic Snap/Hint

Re: Enable snap identifier

PostPosted: Mon Mar 16, 2020 3:20 pm
by joeferguson
Thanks, Roger :)