I seem to have acquired a poison entity. It is a single line drawn by myself on a layer I created.
When I try to erase this entity or move it to another layer, I get a crash and the following error message, "DataCAD (internal diagnostics) fault 28 Error from: 808". Same crash when I try to delete the layer.
Interestingly, the affected layer shows 218 entities in the layer manager but when I zoom extents and count them manually, there are only about two dozen entities. I don't know where the other entities went but now I have to search my whole project and try to find the lines that are not there.
Anybody else experienced this phenomenon? Any ideas on cause or cure?
joe
When I try to erase this entity or move it to another layer, I get a crash and the following error message, "DataCAD (internal diagnostics) fault 28 Error from: 808". Same crash when I try to delete the layer.
Interestingly, the affected layer shows 218 entities in the layer manager but when I zoom extents and count them manually, there are only about two dozen entities. I don't know where the other entities went but now I have to search my whole project and try to find the lines that are not there.
Anybody else experienced this phenomenon? Any ideas on cause or cure?
joe