LOL. Mark Bell asked this same question yesterday, but his was in regards to 3D work. Mine is for 2D work and involves plans for printing.
My drawing files simply have the GotoViews for the print sheets at the end of the GotoView list.
The most recent case is a simple residential drawing sheet with four SelfRef "plans" there-on. They are the Foundation Plan, the Ceiling Framing Plan, the Roof Framing Plan and the Roof Plan. One of the drawings showed all linetypes as it should. The other three showed everything as solid.
I looked at every setting that I could think of that might be controlling the original/solid lines on the SelfRefs. I could find no differences.
I resolved my problem by copying the good SelfRef to the position of each bad one. When I changed the copied SelfRefs to the proper GotoView, the lines all showed correctly.
That seems to indicate that there is some controlling element or setting for Ref'd files that I just don't know about.
Any suggestions as to what I can do with my SelfRefs to achieve consistency would be appreciated... so long as they are physically possible.
Thanks much,
Woody
p.s. There are no double or overlapping lines that might be causing the lines to appear solid.
My drawing files simply have the GotoViews for the print sheets at the end of the GotoView list.
The most recent case is a simple residential drawing sheet with four SelfRef "plans" there-on. They are the Foundation Plan, the Ceiling Framing Plan, the Roof Framing Plan and the Roof Plan. One of the drawings showed all linetypes as it should. The other three showed everything as solid.
I looked at every setting that I could think of that might be controlling the original/solid lines on the SelfRefs. I could find no differences.
I resolved my problem by copying the good SelfRef to the position of each bad one. When I changed the copied SelfRefs to the proper GotoView, the lines all showed correctly.
That seems to indicate that there is some controlling element or setting for Ref'd files that I just don't know about.
Any suggestions as to what I can do with my SelfRefs to achieve consistency would be appreciated... so long as they are physically possible.
Thanks much,
Woody
p.s. There are no double or overlapping lines that might be causing the lines to appear solid.