Use this forum to ask questions about DataCAD 16 and DataCAD LT 16.
#62419 by Neil Blanchard
Fri Nov 15, 2013 3:35 pm
Hi,

When I export a GTV (On Layers) to a R2007-R2009 DWG that includes an XRef that uses an X-Clip and highlighting on the whole XRef - I've tried Binding the XRef to a Symbol and Exporting the XRef, and neither one has the highlighting, and neither one had the X-Clipping.

I can live without the X-Clipping, but I needed the highlighting, so we had to open the exported XRef in ACAD and change everything to match the highlighting, and then reattach the XRef (for whatever reason, it would not show correctly without reattaching?).

Is this "normal"? Or, should the bound symbol, or the XRef be doing the better?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984