We are having an issue when we open drawings that were created in DataCAD 14 or prior that we open in DataCAD 16 (we are using 16.00.01.02). The issue is that the GTV link is turned off in the drawing when we open it. So we lose all of the goto settings that were in the xrefs. in that particular drawing. We then have to turn the GTV link on and try and remember all of the settings that were set previously. This is not happening in all the drawings but in most.
So I have narrowed this down a bit. In all of our pe-16 drawings the GTV Link box in the Xref-Manager is set to off. All of our pre-16 drawings xrefs lose the layer settings when we open them in 16. If we open them in 14 all is good. Is anyone else having this happen is there a way to fix this in 14? IN 14 there wasn't a GTV Link Box in the manager.
David A. Giesselman
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.
Who is online
Users browsing this forum: No registered users and 70 guests