Use this forum to ask questions about DataCAD 16 and DataCAD LT 16.
#64581 by dennisnorton
Sun Jul 20, 2014 6:50 am
I have a fairly large XREF that for some reason I can not snap to intersections of smart walls. I can snap to symbols, etc, but not to the smart walls.

I am using an xref plan to use for projecting interior elevations, so it is very important to be able to snap. I have been able to do this on smaller projects - is there something that I may have accidentally toggles off?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984