Use this forum to ask questions about DataCAD 16 and DataCAD LT 16.
#64889 by Neil Blanchard
Thu Sep 25, 2014 12:33 pm
Hi,

I use Dir/Dis (Direction / Distance) input, and when I am stretching from a snapped Reference Point - and with Ortho on - I am getting small errors in the angle. Sometimes it is a few degrees, and sometimes it is about 23 seconds. I am dragging the direction out well past the point of the end of the stretch. The only way I can avoid this issue is to drag the direct about 2X father than the stretch.

Has any one else seen this? I am using the latest version of v16.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984