Use this forum to ask questions about DataCAD 16 and DataCAD LT 16.
#64908 by Neil Blanchard
Mon Sep 29, 2014 1:00 pm
Hi,

I have a roughly rectangular partial plan that is drawn in a vertical orientation (because of where it is in the building as a whole), and I need to rotate it on the MSP plot sheet so the right side is at the bottom. When I place a door marker symbol, it orients to the drawing correctly, but in the MSP detail (which is rotated 270 degrees) it appears so that is is read from the left side of the sheet. The convention I try to adhere to is to make all text and dims readable from the bottom or the right side of the sheet.

Can this be done with a setting change, or do I need to rotate the symbol?

Edit: it gets much trickier with dimensions. Vertical dims on the drawing become horizontal on the rotated MSP detail - but horizontal dims read from the left side of the sheet. Sorta' upside down ...

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984