Ask questions about DataCAD 16, DataCAD LT 16, or previous versions here.
#69293 by damian
Wed Jun 22, 2016 12:09 pm
Every time I select an entity to offset and it happens to select the wrong entity and disabling the right click, I must once again re-select the offset command. This is a little annoying. There would be a way to avoid this? Thank you

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984