Ask questions about DataCAD 16, DataCAD LT 16, or previous versions here.
#69629 by GuyS
Fri Aug 12, 2016 3:52 pm
I am creating a gable using the 3D vertical slab function. The object will be a gable separating work stations in a commercial project. At present the only way I can add a radius "fillet" to the corner of the vertical slab is by rendering the slab to a 2d image and then filleting the corner. I have many gables to do so being able to do this in 3D would be much better and faster. Perhaps someone has done this and can suggest a way to do it?
(10.17 KiB) Downloaded 159 times
#69632 by GuyS
Fri Aug 12, 2016 4:30 pm
Hum. I'd like to try that. I'll see if I can figure out how to tilt them up....thanks Josh.

Oh and by the way did my pdf come through? Should I use jpegs instead as attachments to my posts?

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984