Hi,
I need to draw a floor drain, so I drew a 6" diameter circle. I then drew the X and Y axis lines (I have Quadrant snap set), and I offset these 3/4" in each direction. I then used Free Trim to get rid of the end segments. And it works about 2/3rds of the time, but the issues are:
It erases the entire line instead of just the shortest end overlaps.
It leaves a point at the intersection of the longer segments, where they crossed each other.
Can anyone confirm this?
I need to draw a floor drain, so I drew a 6" diameter circle. I then drew the X and Y axis lines (I have Quadrant snap set), and I offset these 3/4" in each direction. I then used Free Trim to get rid of the end segments. And it works about 2/3rds of the time, but the issues are:
It erases the entire line instead of just the shortest end overlaps.
It leaves a point at the intersection of the longer segments, where they crossed each other.
Can anyone confirm this?