Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#65988 by matt waters
Fri Feb 27, 2015 8:42 pm
hi, i am trying to open a bitmap i have put into my job on another computer but just pops up with the outline box.
i can get one bitmap to work on 2 computers but not the third. i also have another bitmap that will only open on one computer.

these bitmaps are on a shared drive. any help here would be great. we are taking the same bitmap from the same drive.
but can only see it on our on computers but not anyone elses. the bitmap display button is on all computers too.

please help....
#65997 by Clay Rogers
Mon Mar 02, 2015 1:26 pm
Make sure that the display of bitmaps is enabled in the drawing. Go to the Display menu, and look for "Bitmaps" at the bottom of the menu. If it's off, turn it on.
#66002 by matt waters
Mon Mar 02, 2015 4:59 pm
bitmaps button is on.
im pretty sure all the paths are all the same. the bitmaps are in the same folders on each computer.

i have manage to get my old ones to upload. so i have 2 out of 4 that work. just cant seem to get these other 2 too work
any ideas?
#66004 by wvar
Mon Mar 02, 2015 5:56 pm
I like your Avtar Clay. How true :lol: :lol: :lol:

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984