forum.datacad.com

Posted: **Tue Mar 03, 2015 9:13 am**

Hi
When choosing an image with dashed lines on a drawing using Clipboard Select (under Edit) to transfer to another drawing, the spacings of the dashed lines once transferred are different to those on the original drawing. How do I correct to have the same spacings once moved?
Regards, MichaelB

Posted: **Tue Mar 03, 2015 10:43 am**

When you go into the new drawing and after pressing Ctrl-V, make sure that you pick the Spacing button and that it's set to 1.0.

Posted: **Tue Mar 03, 2015 11:34 am**

It works - many thanks - well appreciated......!!!

Posted: **Tue Mar 03, 2015 12:28 pm**

It's also useful if you're copying something from a larger scale drawing to a smaller scale - just use a number greater than 1.0.

Posted: **Tue Mar 03, 2015 11:51 pm**

Yes - just tried, works well - very good to know. Thank you again.
Best regards
MichaelB

forum.datacad.com

Clipboard Select issue

Clipboard Select issue

Re: Clipboard Select issue

Re: Clipboard Select issue

Re: Clipboard Select issue

Re: Clipboard Select issue