forum.datacad.com

Posted: **Tue May 19, 2015 9:11 am**

Hello,

I think I found a new issue: when I stretch in the 0 degree direction, and then I use the Add 90 button, it says the new direction is 270 degrees, which is fine. But, when I stretch something - it moves in the 90 degree direction.

Maybe this is related to the Get Y + Distance issue?

Posted: **Tue May 19, 2015 10:03 am**

Unable to reproduce.

Posted: **Tue May 19, 2015 11:14 am**

Works as expected for me as well. Are your tangents on by accident?

Posted: **Tue May 19, 2015 12:24 pm**

Nope, Tangents is not on. Lemme check grids... no problem there. Show X and Y is correct, but Show Zero doesn't work.

I will Pak 'N Go the file and email it in.

Posted: **Tue May 19, 2015 12:54 pm**

Clockwise toggled On in the AngleType menu?

Dave

Posted: **Tue May 19, 2015 2:50 pm**

Dave, that is it. I have NEVER even seen that toggle before - or I saw it and forgot about it. Someone else must have done this?

forum.datacad.com

Add 90 Issue

Add 90 Issue

Re: Add 90 Issue

Re: Add 90 Issue

Re: Add 90 Issue

Re: Add 90 Issue

Re: Add 90 Issue