Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#66634 by Rashid Garuba
Mon Jun 15, 2015 8:25 am
So I am doing a complex fence... and AFTER I complete it... oops! forgot something so have to re=fence all 17 clicks again... A "previous selection" to which we can continue will be a big help... This can be added to every other process in which it is relevant.. Like when doing a mirror command and forget "and copy" on, there should be a way to recall the previously selected entities..
#66642 by MtnArch
Tue Jun 16, 2015 9:17 am
This does not work if you "Undo" your move/copy/etc.
#66646 by MtnArch
Tue Jun 16, 2015 12:32 pm
Ahh ... I was mistaken. I had tried it a few weeks back and it didn't work - I must have done something else that cleared out the selection (maybe an auto-save?). Sorry about that guys - I muffed that response!

Who is online

Users browsing this forum: No registered users and 10 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984