Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#66699 by GARY247
Mon Jun 29, 2015 8:47 am
I created a wall using the 4 line function and the 2 line (and copying to create four lines) function. When I go to the create a opening instead of an opening with all four lines it will only pick the lines that are on one side of the drawing. I just tried this at work and it seemed to work fine but on my home computer it will not work. Does it have anything to do with the drawing being created on 17 and modified at home using 15?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984