Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#67101 by Clayton Taylor
Fri Sep 18, 2015 11:36 am
To all,

KnockOut by group..!!

I was drawing up a cut roof plan with polylines as rafters, but then decided to show the walling below. For clarity, I thought it would be a good idea to deploy the "knockout" to the rafters. However as many rafters, I was wondering if you could somehow deploy KnockOut by the normal selection method, i.e. by group, area or fence. However this isn't listed in the menu as far as I can see, so is there a way to do this on mass ? if not, then the normal selection method in the KnockOut menu would be great to see in the future.

Over & out,
Clayton.

Roger D wrote:Change / More / Knockout / Border and then pick by EGAF


Cool........ :D

Thanks for that Roger, I knew there must be a way..........those 50 rafters did take rather a long time to do one at a time.... :oops:

Over & out,
Clayton

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984