Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#67143 by REX PEET
Wed Sep 23, 2015 5:16 pm
Changing the angle will change the overlap. 45 is a good number. I guess the size of the door depends upon the opening size; each leaf being half the opening size.
#67144 by joshhuggins
Wed Sep 23, 2015 5:33 pm
Thanks for the reply Rex, I now realized what I asked for wasn't what I needed to ask. :lol: I did know that the amount the door is open is the angle value, but say the value is set to 0 so the doors are closed the doors are not drawn at 1/2 the opening distance, they are a bit larger so they lap each other still even when fully closed. I guess what I needed to asking for is what determines the door sizes since it's clearly not 1/2 the opening which makes sense since you wouldn't want the door edges right next to each other when closed. I didn't know if it was something we could set, or if there was a standard size that was being used that I may not be aware of. Thanks again.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984