Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#67407 by GARY247
Mon Oct 26, 2015 12:44 pm
Is there any way to change the clean up one line trim function so it stays off unless you click F1(entity) to turn it on? I looked in datacad.ini but did not see anything.
#67408 by David A. Giesselman
Mon Oct 26, 2015 12:54 pm
Look in the [General] section of the INI file for the following key:

1LineTrim By Entity=TRUE

  • If present and TRUE, Entity will always be On.
  • If present and FALSE, Entity will always be Off.
  • If not present, Entity will remember its previous state

Dave

Who is online

Users browsing this forum: No registered users and 5 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984