I am not sure if this is a V18 thing.
I saved a pdf file to jpg at 200 dpi. However, when I imported it into Datacad the bitmap is a very low resolution.
Is there a setting that controls the resolution of bitmaps in Datacad.
I saved a pdf file to jpg at 200 dpi. However, when I imported it into Datacad the bitmap is a very low resolution.
Is there a setting that controls the resolution of bitmaps in Datacad.
Walter
DataCAD user since V3.6E
DataCAD V18 subscriber
DataCAD user since V3.6E
DataCAD V18 subscriber