Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#67983 by dennisnorton
Sat Jan 09, 2016 10:14 am
I have a louvered door as a symbol, with the louvers being drawn as hatch pattern ANSI31 scale 448. For some reason when I insert the symbol into my drawing (normal/full scale) the hatching pattern is way too large. I have never had this occur before. Have I inadvertently toggled something somewhere?

I tried locking the scale and origin in the symbol, but that didn't work either.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984