Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#68498 by GARY247
Fri Apr 01, 2016 3:43 pm
I am doing a site drawing and using the measurement feature. I have set the scale to decimal with 2 digits. Is there any way when I measure the line and apply the measurement to the drawing to get it to include inches even if the inch figure is zero. (N 73-79'-00" E instead of N 73-79' E)

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984