Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#68574 by acormond
Sun Apr 10, 2016 6:17 pm
Sorry if this is the wrong place to post this. Using Datacad 17, if I have a layer with nothing in it, and it's the first layer listed, then when I select it as the only active layer Datacad hangs endlessly. This does not happen if the empty layer is not the first layer in the list. This just started happening, I think.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984