Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#69261 by bradenaia
Mon Jun 20, 2016 7:35 am
Hello again! I am wondering where the setting is that tells Datacad in 2d to not put the arrows in the dimension line when the length is less than say 13". I have looked everywhere i could think of. We now have Datacad 17.04.xx! I feel like i have seen this setting before but i could be wrong.

Thanks in advance!
Bradenaia
#69266 by bradenaia
Mon Jun 20, 2016 9:45 am
Lol true but this is our style and has been since the mid 90's....so we keep them. I thought there was a way to control this in datacad. It changed when we updated to 17.00 and i would love to change it so anything under 13" wont get arrows.

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984