Page 1 of 1

Datacad Dimension Arrows

PostPosted: Mon Jun 20, 2016 7:35 am
by bradenaia
Hello again! I am wondering where the setting is that tells Datacad in 2d to not put the arrows in the dimension line when the length is less than say 13". I have looked everywhere i could think of. We now have Datacad 17.04.xx! I feel like i have seen this setting before but i could be wrong.

Thanks in advance!
Bradenaia

Re: Datacad Dimension Arrows

PostPosted: Mon Jun 20, 2016 8:37 am
by Neil Blanchard
Hi Bradenaia,

We use tick marks so they fit no matter how wide the dimension is. I have not used dimension arrows since my mechanical drafting classroom days. I would have thought that they would flip to the outside of the extension lines?

Re: Datacad Dimension Arrows

PostPosted: Mon Jun 20, 2016 9:45 am
by bradenaia
Lol true but this is our style and has been since the mid 90's....so we keep them. I thought there was a way to control this in datacad. It changed when we updated to 17.00 and i would love to change it so anything under 13" wont get arrows.

Re: Datacad Dimension Arrows

PostPosted: Mon Jun 20, 2016 12:55 pm
by joshhuggins
I don't recall a way to do this.