Use this forum to ask questions about DataCAD 17 and DataCAD LT 17.
#71237 by d keen
Mon Apr 17, 2017 4:45 pm
I am considering a new plotter and presently have a designjet500 that is needing some expensive repair therefore I am looking to upgrade. I am using dcad 17 and design residential and small commercial projects.
The hp120 looks like a good small volume plotter but I would appreciate any comments any users that may have had any experiences with this unit.
Thank you,
Dave Keen/ pacific design architects
#71240 by MtnArch
Mon Apr 17, 2017 6:07 pm
You might want to consider going to a 36" carriage unit as opposed to the 24" that the T120 is. When I upgraded from my DesignJet 450C (24" carriage) I went to a Canon iPF755 (36" carriage) and have never looked back. I'm a one-man office, residential and commercial, and it was an awesome plotter - so much so that after 3 years I traded it in for an iPF785 with a 36" scanner too!
#71265 by d keen
Wed Apr 19, 2017 1:32 pm
Alan,
Thank you for taking the time to respond. I will look in to the Cannon products, I have used Hp for a number of years and have a good trusted support company when needed so I haven't looked at other products.
I can see the scanning capability being of great value so I may consider that option as well.
Sincerely,
Dave Keen

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984