Page 1 of 1

Hatches in symbols not scaling when symbol is enlarged

PostPosted: Mon Dec 11, 2017 6:02 pm
by Richard Mauser
Hi,
This is an oddity that seems to have started recently. When I replace a symbol with another one (in this instance, I made stencil sheet numbers with 'dots' hatch) and the original symbol has been enlarged, the symbol I replace it with won't have the same scaled hatch hatch pattern. Is this normal behavior?
--
Richard

Re: Hatches in symbols not scaling when symbol is enlarged

PostPosted: Tue Dec 12, 2017 9:48 am
by Neil Blanchard
Is the Hatch Scale locked?

Re: Hatches in symbols not scaling when symbol is enlarged

PostPosted: Tue Dec 12, 2017 12:37 pm
by Richard Mauser
Sheer Genius! Thanks Neil.

Apparently when I hatched the other 'stencils' LockScale was on, but when I did that number, it was toggled off. Twitchy finger on the mouse, no doubt.
So, I learn something new today. Like most computer software ("apps" now) I am only scratching the surface.
For those that read this later, with the same question,
Go to: Hatch/HatchType/LockScale ->on
--
Richard

Re: Hatches in symbols not scaling when symbol is enlarged

PostPosted: Tue Dec 12, 2017 1:52 pm
by Neil Blanchard
You're quite welcome, Richard!