Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#73320 by pfblanchard
Mon Feb 26, 2018 10:50 am
I have 2 printing issues to HP 430:
1. When printing a pdf a vertical section of the image does not print even though it shows in print preview
2. the printer ignores orientation in print setup and always prints a size "C" rotated.

Paul B
#73332 by MtnArch
Tue Feb 27, 2018 8:59 am
For your first issue it sounds as if there is an issue with your printhead. Is it the same area regardless of the printed page size (ie. same area whether it's a Ledger size versus a 24x36)?

For the second issue you may need to check your printer properties through Windoze.

Who is online

Users browsing this forum: No registered users and 30 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984