Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#68044 by David Porter
Fri Jan 15, 2016 9:03 am
Found a consistent bug, it would seem, involving QuickLayout percentage change. Tried this with a couple of different printers. Set up the plotting, pick the printer, click QuickLayout. Hover the rectangle over the drawing. Change the printing scale. OK. Hover new rectangle size over drawing. All fits nicely. Go to change the percentage for Quick Layout to show on the screen from the default of 70% to 50%, and immediate crash out of the drawing to a gray screen when I click on the new percentage or type it in and hit Enter. Tried this with a couple of different printers. Didn't matter. Crashed on all of them.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984