Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#68106 by Dave
Sat Jan 23, 2016 9:33 pm
Is there an extended character code for select all

Wanting an alias for free trim/select all/begin

Thanks

Dave
#68107 by Roger D
Sun Jan 24, 2016 9:28 am
not that I know of, but you could add something like
F3^-10000^$^-10000^$^20000^$^20000^$
when you get to the select portion, pick an area 10,000 feet to the lower left of the current location (rel. cart) to a point 20,000 feet to the upper right from there.

I used this to delete all point markers from the file before I send to an engineer who would complain about the time for him to delete the point markers from the door/window centers since he didn't like to see them. I could delete in a second.
#68111 by Dave
Mon Jan 25, 2016 4:54 am
Roger D wrote:not that I know of, but you could add something like
F3^-10000^$^-10000^$^20000^$^20000^$

Thanks. I'll give this a shot

Dave

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984