Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#68814 by DBrennfoerder
Thu May 05, 2016 7:47 am
Thanks gurus. I know I used to have a problem when loading "MnFlr" this job and "MnFlr" that job at the same time because there was a DataCAD problem when opening two files with the same name, so I've avoided doing that for a long time. I see that has been changed and is not now a problem. Thanks again. May have been an Easter Egg, might have been documented; don't spend much time reading bug/fixes, sorry. Just trying to make a living and y'all make it fun, too.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984